Lab 1. Belt Conveyor
Subject: the study and parameters calculation of a belt conveyor.
Purpose: to study the structure and peruse of the belt conveyors operating principle; to determine the main parameters of the conveyor (productivity, length of transportation, speed of the load).
Order of execution:
1. Draw up the scheme of the belt conveyor offered by the instructor for studying. Show main parts of the conveyor
2. Thoroughly study the proposed laboratory installation and perform measurements of structural dimension and set them into the table.
2. Make conclusions about the design of the belt conveyor elements, which is considered during the laboratory class (the belt tension method, the complexity of the drive, adjusting of the belt, unloading of the belt conveyor etc.).
3. Make the draft of the belt ends joint
4. Show the result of calculations of conveyor productivity
Laboratory class conclusions with suggestions about improvement of belt conveyors operation.
The report should be properly prepared. Each of the report must be discussed with the lecturer to reveal the level of the student’s knowledge and skills.
Evaluation of the report: maximal score is 10:
8-10 - without comments on the report and meaningful and complete answers during the discussion (defend).
5-7 - there are minor errors in the report and meaningful and complete answers during the discussion;
3-4 - there are minor errors in the report and the issues are not explained properly during the discussion;
1-2 - there are major errors in the report and issues are not explained properly during the discussion.
Deadline: not later a week after its execution.
Methodological support: blank of the report to fill see below.
- 29 січня 2021, 19:11
Шрифти
Розмір шрифта
Колір тексту
Колір тла
Кернінг шрифтів
Видимість картинок
Інтервал між літерами
Висота рядка
Виділити посилання